Running Device Installation Wizard in Communication Manager 5.x
SUBJECT:
Running Device Installation Wizard in Communication Manager 5.x
FACT:
Communication Manager 5.0
Communication Manager 5.1
Communication Manager 5.2
Communication Manager 5.3
Communication Manager 5.4
SYMPTOM:
Modem / Tethering
ADVISORY:
IMPORTANT: Do not run the Device Wizard in Communication Manager if you are using a PC card modem. Doing so may adversely affect the stability of your connection to the AT&T wireless network. If the Device Wizard was inadvertently executed, see this article to re-establish the communication between the PC card modem and Windows.
  1. Open Communication Manager by either:
    • Double clicking the Desktop icon.
    • Clicking Start > Programs > Cingular > Communication Manager.
      NOTE: Depending on the version installed, the actual Start menu path may differ in verbiage. Look for "Cingular" in any event.
  2. Select Tools > Device Wizard...
    IMPORTANT    : Do not insert or connect device until prompted to do so by the software.

  3. Click Next.

  4. Select device, click Next.
    IMPORTANT: Do not run the Device Wizard in Communication Manager if you are using a PC card modem. Doing so may adversely affect the stability of your connection to the AT&T wireless network. If the Device Wizard was inadvertently executed, see this article to re-establish the communication between the PC card modem and Windows.

  5. Installing device drivers.

  6. Insert or connect the device. The Device Configuration Wizard will automatically configure the device.
  7. Click Next.

  8. Detecting device.

  9. The device has been configured, click Next.

  10. The device is now ready for use, click Finish.




If you are viewing information on devices or services, please note: content reflects instructions for devices and services purchased from AT&T.
Some differences may exist for devices not purchased from AT&T.

Top